Echosystem

What will I lose upgrading to Echosystem from Superdelay or Vintage Modified Super delay?
What will I lose upgrading to Echosystem from Superdelay or Vintage Modified Super delay? 1. Hardware, Inputs/Outputs The echosystem expands on everyth...
Mon, 8 May, 2017 at 11:12 AM
Are output volumes in serial engine routing are linked?
Yes, this is by design.  By adding gain between the engines it's really easy to distort the signal internally and it leads to really nasty sounds and ...
Thu, 6 Jul, 2017 at 10:08 AM
Feedback not working with the Hardware Insert?
This happens when you have the external pedal's input and output plugged in backwards.  You hear only one repeat and the feedback control does noth...
Thu, 6 Jul, 2017 at 10:11 AM
Will I lose my saved presets when I update to the new firmware hotness?
Updating the firmware will not affect your presets; however, we recommend keeping a log of all of your settings just in case something happens. Issu...
Thu, 10 Aug, 2017 at 8:59 AM
Noisy input jack issues
We are not all made equal and normally size doesn't matter, but in this case... it does. Some patch cables are slightly smaller spec than what the ...
Mon, 15 Jan, 2018 at 8:35 AM
How do I see which engine is first in line in 'dual serial' routing mode?
There's 2 ways to see which engine is first: 1.  When you go to a serial preset the first engine will always be what shows bright when it's recal...
Mon, 4 Dec, 2017 at 11:58 AM
Can I power my Echosystem with a VooDoo Lab PP2+ ?
Yes you can! Use either port 5 or 6 in the NORMAL position with a standard negative tip power chord. If you're having any issues, please conta...
Fri, 2 Mar, 2018 at 11:28 AM
How do I set up a Boss FS-5U as an external tap?
In advanced configuration, set TAPE to #4. BOSS tends to use NC footswitches.
Fri, 2 Mar, 2018 at 3:10 PM
What firmware version is loaded on my Empress Echosystem?
Here's a nice little video on how to figure this out. Note that video features the Empress Reverb, but that the process for figuring out the firmware ve...
Fri, 9 Mar, 2018 at 2:13 PM
Echosystem Factory Presets - Knob Values
Mode values start from 0, like it does in code Mode values : first digit represents the mode and the second digit represents the submode Knob values : 0.0...
Wed, 2 May, 2018 at 11:10 AM